Most Evenflo seats don’t mandate using the tether in cases where you don’t have an available tether anchor, however, Revolve 360 is unique and it DOES require tethering. In this day and age, tethering shouldn’t be a problem unless you plan evenflo car seat and stroller to use this seat in the 3rd row of a vehicle. Vehicles with a 3rd row usually don’t have a tether anchor for every seating position back there, so make sure you know where the tether anchors are and where they’re not in your vehicle.
Evenflo does recommend raising or removing the head restraint if it interferes with the seat locking into the forward-facing position. Same process as above but using the LATCH strap instead of the seatbelt. You still utilize the LockStrong bar (after you’ve slightly tensioned the latch strap) and you still need to tether. I actually found it easier to achieve a rock-solid installation using seatbelt, so unless you have a compelling reason to use latch, I’d suggest sticking with a seatbelt installation. It was a little challenging for me to tighten the latch strap initially.
Some latch straps have a little loop sewn into the loose tail end that you can slip your index finger into and pull, but this strap didn’t have that option. Therefore, it took a little more effort for me to tighten the latch strap enough to yield a solid installation after the LockStrong bar was shut and locked. Once again, make sure you reference the visual indicator on the inside of the base to confirm that it has turned from red to fully green – indicating that the LockStrong bar is securely locked. Read on to learn how to put your car seat back together after removing the seat cover. If you need some more guidance, this short video will show you to install your Evenflo convertible car seat in the forward-facing position.
Anyways, two weeks passed so I decide to check my order status. I contact customer service and they stated without an account created at checkout I could not view my order status. She proceeded to tell me that my order was “in process”. I said okay and patiently waited for that email as to when my order was being shipped. The stroller frame only comes off the car seat’s carrier portion when it is in the base. The stroller frame will then be locked in the base until you reattach the carrier portion of the seat to it.
The main portion of the harness covers are referred to as “harness strap pads” and these have a grippy material sewn into the underside of the pads. I flipped it over to photograph the grippy material but I want to be clear that this is the backside of the harness strap pad which will be making contact with your child’s clothing. Pull the seat cover around the shell of the car seat and attach it to the plastic clips.